Orifice Installation - Wolf CG Series Service Manual

Remove the Burner Cap
Remove the burner cap from the burner assembly.
Remove the Burner Assembly
1 Use a T-15 Torx bit to remove the screws holding the burner
assembly to the orifice holder.
2 Lift the burner assembly from the burner pan.
3 Remove the electrode wire from the igniter.
4 Remove the burner assembly from the unit.
Igniter
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
Burner Cap
Burner Assembly
Electrode Wire
Remove the Orifice
9
Use a / " socket with extension to remove the orifice from
32
the orifice holder.
Main
Orifice

ORIFICE INSTALLATION

WARNING
When installing the orifice to the orifice holder, only
pipe thread compound should be used. Do not use
Teflon tape to seal gas connections.
Install the Orifice
9
Use a / " socket with extension to install the orifice into
32
the orifice holder.
Install the Burner Assembly
1 Attach the electrode wire to the igniter.
2 Place the burner assembly into the burner pan.
3 Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
Install the Burner Cap
Place the burner cap onto the burner assembly.
Install the Burner Grate
Place the burner grate onto the cooktop.
8
service.subzero.com
Simmer
Orifice