Table of Contents
Advertisement
2 2
2 2
Component Access and Removal
G G A A S S C C O O O O K K T T O O P P - -
S S E E R R I I E E S S
G G A A S S C C O O O O K K T T O O P P - -
S S E E R R I I E E S S
Outer Distribution Ring Removal
The outer distribution ring routes the gas from the main
burner orifice hood to the main burner holes at the top
of the burner head. To remove the outer distribution
ring, follow the preliminary steps listed at the beginning
of this section. Then, using wrenches, disconnect the
flexible gas tube that is mounted to the outer distribu-
tion ring connector. Next, lift the outer distribution ring
from the jet holder. There are two different sized O-
rings, which sit in grooves in the outer distribution ring.
(See Figure 4-6).
Jet Holder Removal
The jet holder is mounted to burner mounting bracket
on the bottom of the burner box. The main burner ori-
fice is threaded into the jet holder as well as the venturi.
In order to remove the jet holder, the preliminary steps
listed at the beginning of this section will need to be
removed first. Then, disconnect the flexible gas tube
that is mounted to the jet holder. Now, extract the nuts
from the pem studs that secure the jet holder to the
burner mounting bracket and lift the jet holder off.
(See Figure 4-7).
Burner Mounting Bracket Removal
The burner mounting bracket is mounted to the bottom
Figure 4-6. Outer Distribution Ring Removal
of the burner box and acts as a spacer to keep the sur-
face burner components at the proper height. Two
studs that protrude upward from the bottom of the burn-
er box are used to secure both the burner mounting
bracket and the jet holder. To remove the burner
mounting bracket, follow the preliminary steps listed at
the beginning of this section first. Then, slide the burn-
er mounting bracket up and off of the protruding studs.
Simmer
(See Figure 4-7).
Orifice
Surface Burner Orifice Removal
Simmer - The simmer orifice is hex shaped and
Main
Orifice
attached to the inside of the outer distribution ring. Use
a wrench to remove it.
Main - The main orifice is hex shaped and is attached
to the bottom of the jet holder. Use a nut driver or
socket to remove it.
(See Figure 4-7).
NOTE: Main orifice is included with jet holder. See
parts list and exploded views for appropriate compo-
nent.
Figure 4-7. Jet Holder, Bracket & Orifice Removal
4-5
Advertisement
Table of Contents
Troubleshooting
