Wolf CG Series Service Manual page 13

REMOVE ALL BEZELS (continued)
4 Remove the bezel from the unit.
Remove All Burner Assemblies
To remove each burner assembly:
1 Use a T-15 Torx bit to remove the screws holding the burner
assembly to the orifice holder.
2 Lift the burner assembly from the burner pan.
3 Remove the electrode wire from the igniter.
4 Remove the burner assembly from the unit.
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
Burner Cap
Burner Assembly
Igniter
Electrode Wire
Remove the Burner Pan
Lift the burner pan from the burner box.
Remove the Receptacle
1 Use a Phillips screwdriver to remove the mounting screws
from the receptacle.
2 Remove the receptacle from the unit.
RECEPTACLE INSTALLATION
Install the Receptacle
1 Install the receptacle onto the burner valve.
2 Use a Phillips screwdriver to install the mounting screws
into the receptacle.
Install the Burner Pan
Place the burner pan on the burner box.
12
service.subzero.com