Wolf CG Series Service Manual page 19

Install All Burner Assemblies
To install each burner assembly:
1 Attach the electrode wire to the igniter.
2 Place the burner assembly into the burner pan.
3 Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
Install All Bezels
To install each bezel:
1 Connect the bezel to the light wire harness.
2 Insert the bezel into the unit.
3 Twist the bezel 90° clockwise.
Install All Knobs
Push each knob onto each valve shaft.
Install the Unit
Install the unit.
Install All Burner Caps
Install all burner caps onto the burner assemblies.
Install All Burner Grates
Place all burner grates onto the cooktop.
BURNER VALVE REMOVAL
To remove the burner valve, first remove the burner grates and
burner caps. Uninstall the unit, and then remove the knobs,
bezels, burner assemblies, burner pan, and receptacles.
WARNING
Turn off the power and gas to the product before
starting this procedure.
CAUTION
If the gas line is not long enough to stay connected
when the unit is pulled out of the opening, the gas
may need to be disconnected.
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
Remove All Burner Grates
Lift all burner grates from the unit.
Remove All Burner Caps
Remove all burner caps from the burner assemblies.
Uninstall the Unit
Remove the unit from the installation.
18
service.subzero.com