Wolf CG Series Service Manual page 27

Remove the Burner Grate
Lift the burner grate from the unit.
Remove the Burner Cap
Remove the burner cap from the burner assembly.
Remove the Burner Assembly
1 Use a T-15 Torx bit to remove the screws holding the burner
assembly to the orifice holder.
2 Lift the burner assembly from the burner pan.
3 Remove the electrode wire from the igniter.
828386 REV. A 06/2018
CG Professional Gas Cooktop Service Manual
4 Remove the burner assembly from the unit.
Remove the Electrode Wire
1 On the bottom of the unit, use a
remove the screw holding the igniter bracket to the burner
box.
2 Lower the screw side of the igniter bracket.
3 Disconnect the electrode wire from the spark module.
4 Remove the electrode wire from the unit.
ELECTRODE WIRE INSTALLATION
Install the Electrode Wire
1 Feed the electrode wire from the burner assembly opening
down to the spark module.
2 Anchor the electrode wire to the burner assembly.
3 Connect the electrode wire to the spark module.
4 Raise the igniter bracket into the burner box.
5 Use a Phillips screwdriver to install the screw through the
igniter bracket in the base of the unit.
26
service.subzero.com
Burner Cap
Burner Assembly
Igniter
Electrode Wire
1
/ " nut driver or socket to
4