Denso BHT-100B User Manual page 99

Testing the direct-connect interface port
Chapter 2. Getting Started the BHT and System Mode
Upon normal completion of the test, the tested
slave BHT beeps once and shows the screen at
left.
Press the C key to return to the TEST COM menu.
The master BHT will automatically return to the
MASTER/SLAVE selection menu.
Selecting the "2:CONNECTOR" on the TEST COM
menu displays the screen shown at left and then
starts testing the direct-connect interface port.
If any error occurs, the BHT beeps three times and
shows the screen at left.
In parentheses are error codes which have the
following meanings:
(X X)
1: The received data is different from
the sent data.
2: A timeout has occurred during
standby for data reception.
1: 300 bps
2: 115200 bps
83