Communicating With The Host Computer; Setting The Transmission Speed Of The Cu-7000; Interface Cable Connection - Denso BHT-100B User Manual

5.4 Communicating with the Host
Computer

5.4.1 Setting the Transmission Speed of the CU-7000

Set the transmission speed of the CU-7000 to the same value as that of the BHT and the
host computer, by using the DIP switch provided on the bottom of the CU-7000.
(1) Turn the CU-7000 upside down.
(2) Remove the protection sheet of the DIP switch from the CU-7000.
(3) Set the selectors of the DIP switch as shown below.
DIP switch (when
the protection
sheet is removed)
(4) Reinstall the protection sheet.
Do not set the DIP switch to any configurations other than one of the five shown
above.

5.4.2 Interface Cable Connection

(1) Unplug the AC adapter of the CU-7000 from the wall socket.
(2) Make sure that the host computer is turned off.
(3) Connect the 25-pin plug (Dsub-25P) of the interface cable to the RS-232C interface
port of the CU-7000.
(4) Connect the other end of the interface cable to the RS-232C port of the host
computer.
1 2 3
OFF
Bottom View
142
For 115,200 bps For 57,600 bps
1 2 3
ON
OFF
OFF
For 38,400 bps For 19,200 bps
1 2 3
ON
OFF
OFF
For 9,600 bps
1 2 3
ON
OFF
OFF
RS-232C interface
cable
1 2 3
ON
OFF
OFF
1 2 3
ON
OFF
OFF