Table of Contents
Advertisement
(2)
Communications protocol option screen
Chapter 2. Getting Started the BHT and System Mode
Selecting "2:PROTOCOL" on the SET CONNECTOR
screen calls up the screen shown at left.
Highlighted is the current setting.
1 SERIAL No.:
2 H. PARITY:
3 LINKUP TIME:
4 FIELD SPACE:
Select a desired item by using the numerical keys
or M1 and M2 keys. Then select a desired setting
by using the SF+M1 and SF+M2 keys.
To return to the SET CONNECTOR screen, press
the C key.
If the BHT-Ir protocol has been selected, the
serial number and horizontal parity settings
will be ignored.
67
Selects whether or not the
system will add serial num-
bers to data blocks.
Selects whether or not the
system will add a horizontal
parity.
Selects the timeout length (in
seconds) to be applied when
a link is to be established.
Selects whether space codes
in the tail of a data field will
be ignored or handled as
data.
Advertisement
Chapters
Table of Contents
