D.2
Interface Cables
With the interface cables described in this section, DENSO WAVE has run the quality
assurance test conforming to the EMC Directive for the BHT-100Q/100B series and CU-
7001.
Any connectors other than those specified here are not acceptable. They may cause
the BHT or CU to fail to work according to the specifications.
For BHT
Cable 1
Wind the cable on a ferrite core twice and then secure the core with a heat-shrinkable
tube.
➀
Connector
➁
D-sub connector
➂
Connector cover
➃
Cable
➄
Ferrite core
➅
Heat-shrinkable tube
Note: A square ( ) in the above specifications denotes a numeral that will vary
according to the number of connector pins.
P161
D -F-T-N series (EMI-durable)
17JE series hood/cable clamp
(shielded)
Super flex VVC 7/0.18 mm x 3C
ZCAT2035-0930A
186
Teisin Electric Co., Ltd.
Japan Aviation
Electronics Industry Ltd.
DDK Ltd.
Bando Densen Co., Ltd.
TDK Corporation