Table of Contents
Advertisement
Activ8X® Pipe™
case Front controls
1
7
8
2
14
11
12
13
5
1. Wire Feed Speed Digital Display - The Activ8X has a digital
display that shows the wire feed speed. This display is also
capable of displaying amperage and the setup menu.
2. Wire Feed Speed Knob - Use the Wire Feed Speed Knob to set
the rate of wire feed speed. The wire feed speed will be
displayed on the Wire Feed Speed Digital Display. During CV
operation, the wire feed speed will remain a constant value,
independent of arc voltage changes, as along as the arc
voltage does not drop below the values per the following table.
3
9
10
4
3. Voltage Digital Display - The Activ8X has a digital display that
6
4. Voltage/Trim Knob - Use the Voltage Knob to set the voltage
15
5
5
5.
6.
7. Wire Feed Speed LED - The Wire Feed Speed and Amperage
8. Amperage LED - When the Amperage LED is illuminated,
9. Voltage LED - The Voltage LED will be illuminated when the
10. Trim LED - When the Trim LED is illuminated, a Trim value is
11. Five Pin Gun Trigger Connector - The 5 Pin Gun Trigger
12. On/Off Switch- Enables/Disables power to the Acti8X Pipe. It does not
13. Work Clamp Connection (TWECO)
14. Menu Selection and Adjustment - Push for a half second to enter the
15. Memory Button - Push to select between 4 memory locations. Push and
B-11
shows the voltage between electrode and work
when connected to a CrossLinc™ Power Source. The voltage
will be displayed on the Voltage Digital Display. During CV
operation, the voltage will remain stable while welding.
Alphanumeric Display - Shows wire type, wire size, process
name, gas type, active procedure and active memory. This
display is also capable of displaying settings menu parameters.
CrossLinc™ LED - The CrossLinc LED displays whether the
feeder is connected to a CrossLinc compatible power source.
When the feeder has successfully connected to the power
source, the LED will illuminate.
LEDs will communicate what is being displayed on the Wire
Feed Speed Digital Display. When the Wire Feed Speed LED is
illuminated, wire feed speed is being displayed.
amperage is being displayed.
Voltage Digital Display is displaying actual voltage.
being displayed.
Connector is where the trigger that is attached to the welding
gun is connected. This will actuate the welding current when
the trigger is pulled.
control the power to the welding power source.
menu screens, turn knob to display the memory options. Push the knob
again to confirm menu selection/
hold to save the active weld schedule. The memory buttom also serves as
an exit button while in the menu screen.
OPERATION
Advertisement
Table of Contents
