Table of Contents
Advertisement
Activ8X® Pipe™
Digital Meter Displays
While Idle:
The left display shows the preset wire feed speed. The right
display shows the preset voltage when it is connected to a
compatible power source.
While Welding:
The value in the left display will be either amps or actual wire feed
speed, depending upon the selection chosen in the set-up menu.
The corresponding LED on the sides of the display will light. For
non-synergic welding modes, the right display will show actual
votlage.
FIGURE B.1
VOLTAGE DISPLAY IN NON-SYNERGIC WELDING
The voltage display is determined by the welding mode. For
non-synergic welding modes, the right display will show actual
votlage.
VOLTAGE DISPLAY IN SYNERGIC WELDING
For synergic CV modes, the right display will show trim.
When the right knob is rotated, the display will show an upper
or lower bar if the voltage is above or below the ideal voltage
Preset voltage above ideal (lower bar displayed for 1 second).
Preset voltage is ideal.
Preset voltage below ideal (lower bar displayed for 1 second).
Note: Changing the WFS will result in the preset voltage
following the set wire feed speed as a synergic setting.
SYNERGIC PULSE
Pulse welding controls the arc length with "Trim" instead of
voltage. When trim (arc length is adjusted with the knob, the
machine automatically recalculates the voltage, current and time
of each part of the pulse waveform for the best result. Trim
adjusts the arc length and ranges from 0.50 to 1.50.
Note: the Trim display can be changed back to showing volts in
the set-up menu.
B-4
OPERATION
FIGURE B.2
FIGURE B.3
FIGURE B.4
Advertisement
Table of Contents
