Safety; General Safety Instructions; Recommendations; Liabilities - Baxi PRIME Series Installation Manual

1.

SAFETY

1.1

General safety instructions

SMELL OF GAS
• Switch off the boiler.
• Do not activate any electrical device (such as switching on the light).
• Put out any naked flames and open the windows.
• Call an Authorised Service Centre.
SMELL OF COMBUSTION FUMES
• Switch off the boiler.
• Open all the doors and windows to ventilate the room.
• Call an Authorised Service Centre.
FLAMMABLE MATERIAL
Do not use and/or store highly flammable material (thinners, paper, etc.) near the boiler.
SERVICING AND CLEANING THE BOILER
Switch off the boiler before working on it.
1.2

Recommendations

Only qualified technicians are authorised to service the device and system.
The appliance is not intended to be used by persons with reduced physical, sensory or mental capacities, or who lack
experience or knowledge, unless, through the mediation of a person responsible for their safety, they have had the benefit
of supervision or of instructions on the use of the appliance.
Failure to observe the above will render the warranty null and void. Prior to commissioning, remove the protective plastic
coating from the boiler. Do not use any tools or abrasive detergents to do this as you may damage the painted surfaces.
Do not leave any packaging (plastic bags, polystyrene, etc.) within the reach of children as they are a potential source of danger.
SOLAR WARNING
If the instantaneous (mixed) boiler is connected to a system with solar panels, the maximum temperature of the domestic hot water
entering the boiler must not exceed 60°C.
1.3

Liabilities

1.3.1 RESPONSIBILITIES OF THE INSTALLER
The installer is responsible for installation and commissioning of the device. The installer must follow the instructions below:
• Read and observe the instructions in the manuals provided with the device.
• Install the device in compliance with the laws and standards in force.
• Perform commissioning and all necessary checks.
• Explain installation to the user.
• With regard to maintenance, inform the user of the need to check the device regularly and to keep it in good working order.
• Provide the user with all the instruction manuals.
1.3.2 RESPONSIBILITIES OF THE PRODUCER
Our products all have marking. As our company constantly strives to improve its products, it reserves the right to modify the
information given in this document at any time and without notice. This document is issued purely for the sake of information and
should not be considered as a contract with third parties. As the producer, we cannot be held responsible for the following:
• Failure to observe the instructions on installation of the device.
• Failure to observe the instructions on use of the device.
• Negligent or insufficient maintenance of the device.
3 7696306 (01-12/17)