Table of Contents
Advertisement
Transparent mode installation
This chapter describes how to install your DFL-500 NPG in Transparent mode. If you want to install the DFL-
500 NPG in NAT/Route mode, see
This chapter includes:
•
Preparing to configure Transparent mode
•
Using the setup wizard
•
Using the command line interface
•
Setting the date and time
•
Connecting to your network
Preparing to configure Transparent mode
Use
Transparent mode settings
Transparent mode settings
Administrator Password:
Management
IP:
DNS Settings:
Using the setup wizard
From the web-based manager you can use the setup wizard to create the initial configuration of your DFL-500
NPG. To connect to the web-based manager, see
Changing to Transparent mode
The first time that you connect to the DFL-500 NPG it is configured to run in NAT/Route mode. To switch to
Transparent mode using the web-based manager:
•
Go to System > Status .
•
Select Change to Transparent Mode.
•
Select Transparent in the Operation Mode list.
•
Select OK.
The DFL-500 NPG changes to Transparent mode.
To reconnect to the web-based manager, change the IP address of your management computer to 10.10.10.2.
Connect to the DFL-500 NPG internal interface and browse to https:// followed by the transparent mode
management IP address. The default transparent mode Management IP address is 10.10.10.1.
DFL-500 User Manual
NAT/Route mode
to gather the information you need to customize Transparent mode settings.
IP:
Netmask:
Default Gateway:
The management IP address and netmask must be valid for the network from which you will
manage the DFL-500 NPG. Add a default gateway if the DFL-500 NPG must connect to a router
to reach the management computer.
Primary DNS Server:
Secondary DNS
Server:
installation.
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
Connecting to the web-based
manager.
19
Advertisement
Table of Contents
