Getting Started; Package Contents; Mounting - D-Link D DFL-500 DFL-500 Manual

Network security firewall
Table of Contents

Advertisement

Getting started

This chapter describes unpacking, setting up, and powering on your DFL-500 NPG. When you have
completed the procedures in this chapter, you can proceed to one of the following:
If you are going to run your DFL-500 NPG in NAT/Route mode, go to
If you are going to run your DFL-500 NPG in Transparent mode, go to
This chapter includes:

Package contents

Mounting

Powering on
Initial configuration
Connecting to the web-based manager
Connecting to the command line interface (CLI)
Next steps
Package contents
The DFL-500 package contains the following items:
the DFL-500 NPG
one orange cross-over ethernet cable
one gray regular ethernet cable
one null-modem cable
DFL-500 QuickStart Guide
A CD containing this DFL-500 User Manual and the DFL-500 CLI Reference Guide
one AC adapter
DFL-500 package contents
Mounting
The DFL-500 NPG can be installed on any stable surface. Make sure that the appliance has at least 1.5 in.
(3.75 cm) of clearance on each side to allow for adequate air flow and cooling.
DFL-500 User Manual
NAT/Route mode
installation.
Transparent mode
installation.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfl-500

Table of Contents