D-Link D DFL-500 DFL-500 Manual page 83

•
Enter the following command to restart the DFL-500 NPG:
> execute reboot
As the DFL-500 NPG reboots, messages similar to the following appear:
BIOS Version 2.2
Serial number: FGT-502801021075
SDRAM Initialization.
Scanning PCI Bus...Done.
Total RAM: 256M
Enabling Cache...Done.
Allocating PCI Resources...Done.
Zeroing IRQ Settings...Done.
Enabling Interrupts...Done.
Configuring L2 Cache...Done.
Boot Up, Boot Device Capacity=62592k Bytes.
Press Any Key To Download Boot Image.
...
•
Quickly press any key to interrupt system startup.
The following message appears:
Enter TFTP Server Address [192.168.1.168]:
You only have 3 seconds to press any key. If you do not press any key soon enough, the DFL-500 reboots
and you must log in and repeat the execute reboot command.
•
Type the address of the TFTP server and press Enter.
The following message appears:
Enter Local Address [192.168.1.188]:
•
Type the address of the internal interface of the DFL-500 and press Enter.
The following message appears:
Enter File Name [image.out]:
•
Enter the firmware image file name and press Enter.
The TFTP server uploads the firmware image file to the DFL-500 and messages similar to the
following appear:
Total 7682959 Bytes Data Is Downloaded.
Testing The Boot Image Now.
Total 32768k Bytes Are Unzipped.
Do You Want To Save The Image ?[Y/n]
•
Type Y .
Programming The Boot Device Now.
................................
Read Boot Image 548405 Bytes.
Initializing Firewall ...
DFL-500 Login:
The installation might take a few minutes to complete.
You can then restore your previous configuration. Begin by changing the interface addresses if
required. You can do this from the web-based manager or from the CLI using the command:
set system interface
DFL-500 User Manual
83