Table of Contents
Advertisement
•
Select New to add an administrator account.
•
Type a login name for the administrator account.
The login name must be at least 6 characters long and can contain numbers (0-9), and upper case
and lowercase letters (A-Z, a-z), and the special characters - and _. Other special characters and
spaces are not allowed.
•
Type and confirm a password for the administrator account.
The password must be at least 6 characters long and can contain numbers (0-9), and uppercase and
lowercase letters (A-Z, a-z), and the special characters - and _. Other special characters and spaces
are not allowed.
•
Optionally type a Trusted Host IP address and netmask for the location from which the administrator
can log into the web-based manager.
If you want the administrator to be able to access the DFL-500 NPG from any address, set the trusted
host to 0.0.0.0 and the wildcard mask to 255.255.255.255.
To limit the administrator to only be able to access the DFL-500 NPG from a specific network, set
trusted host to the address of this network and set the wildcard mask to the netmask for this network.
For example, to limit an administrator to accessing the DFL-500 NPG from your internal network, set
the trusted host to the address of your internal network (for example, 192.168.1.0) and set the
wildcard mask to 255.255.255.0.
•
Set the Permission level for the administrator.
•
Select OK to add the administrator account.
Editing administrator accounts
The admin account user can change individual administrator account passwords, configure the IP addresses
from which administrators can access the web-based manager, and change the administrator permission
levels.
Administrator account users with Read & Write access can change their own administrator passwords.
Configuring SNMP
Configure SNMP for the DFL-500 NPG so that the SNMP agent running on the DFL-500 NPG can report
system information and send traps. The DFL-500 agent supports SNMP v1 and v2c. System information can
be monitored by any SNMP manager configured to get system information from your DFL-500 NPG. Your
SNMP manager can use GET (GET-NEXT) SNMP operations to communicate with the DFL-500 agent.
Configuring the DFL-500 NPG for SNMP connections
Before a remote SNMP manager can connect to the DFL-500 SNMP agent, you must configure one or more
DFL-500 NPG interfaces to accept SNMP connections. For information about how to do this, see
the internal interface
and related interface configuration sections.
Configuring SNMP
•
Go to System > Config > SNMP .
•
Select Enable SNMP.
•
Configure SNMP settings.
System Name
DFL-500 User Manual
Type a name for this DFL-500 NPG. The system name can be up to 31 characters long and can
contain, numbers (0-9), uppercase and lowercase letters (A-Z, a-z), and the special characters -
and _. Spaces and the \ < > [ ] ` $ % & characters are not allowed.
Configuring
99
Advertisement
Table of Contents
