Changing To Transparent Mode; Changing To Nat/Route Mode - D-Link D DFL-500 DFL-500 Manual

Network security firewall
Table of Contents

Advertisement

This procedure deletes the changes that you have made to the DFL-500 NPG configuration and reverts the system
to its original configuration, including resetting interface addresses.
Go to System > Status .
Select Restore Factory Defaults.
Select OK to confirm.
The DFL-500 NPG restarts with the configuration that it had when it was first powered on.
Reconnect to the web-based manager and review the system configuration to confirm that it has been
reset to the default settings.
You can restore your system settings by uploading a previously downloaded system settings text file to the
DFL-500 NPG.

Changing to Transparent mode

Use the following procedure if you want to switch the DFL-500 NPG from NAT/Route mode to Transparent
mode.
Changing to Transparent mode deletes all NAT/Route mode policies and addresses. In addition any routing
set in NAT/Route mode is also deleted. This includes the default route that is part of the default NAT/Route
configuration.
Go to System > Status .
Select Change to Transparent Mode.
Select Transparent in the operation mode list.
Select OK.
The DFL-500 NPG changes operation mode.
To reconnect to the web-based manager, connect to the interface configured for Transparent mode
management access and browse to https:// followed by the Transparent mode management IP
address.
By default in Transparent mode, you can connect to the internal interface. The default Transparent
mode management IP address is 10.10.10.1. See
(Transparent
mode).

Changing to NAT/Route mode

Use the following procedure if you want to switch the DFL-500 NPG from Transparent mode to NAT/Route
mode.
Changing to NAT/Route mode deletes all Transparent mode policies and addresses. In addition any routing
set in Transparent mode is also deleted. This includes the default route that is part of the default Transparent
mode configuration.
Go to System > Status .
Select Change to NAT Mode.
Select NAT/Route in the operation mode list.
Select OK.
DFL-500 User Manual
Configuring the management interface
85

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfl-500

Table of Contents