Table of Contents
Advertisement
Problem
The anti-flood device is on and an
intermittent acoustic signal sounds
for approximately 30 seconds.
The display shows E4.
Technical malfunction of the appli-
ance.
The display shows Ed.
Once you have checked the appliance, set and
start the programme again. If the problem occurs
again, contact an Authorised Service Centre.
THE DISHWASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
The dishes are not clean.
Scale particles on the dishes.
There are streaks or milky
stains on glasses and dishes.
14
•
Close the water tap and contact an Authorised Service
Centre.
•
Contact an Authorised Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
Possible cause
The selected programme was
not applicable for the type of
load and / or for the degree of
soil.
The basket was not loaded
correctly, water did not reach
all surfaces.
The spray arm could not turn
freely because of the incorrect
arrangement of the load.
The filters are clogged.
The filters are not correctly as-
sembled and installed.
The quantity of detergent was
not enough or no detergent
was used.
The salt container is empty.
The cap of the salt container is
not closed correctly.
The level of the water softener
is too high.
Possible solution
Possible solution
Make sure that the programme
is suitable to the type of load
and / or for the degree of soil.
Load the basket correctly.
Make sure that the spray arm
can turn freely before you start
a programme.
Make sure that the filters are
clean.
Make sure that the filters are
correctly assembled and instal-
led.
Make sure that a correct
amount of detergent is used.
Fill the salt container with spe-
cific salt for dishwashers.
Make sure that the salt con-
tainer is correctly closed.
Set the water softener to a
lower level.
Advertisement
Table of Contents
