Warning! Risk of fire and electrical the water flow until it is clean. shock. • The first time you use the appliance, make sure that there is no leakage. • The appliance must be earthed. www.zanussi.com...
• Put knives and cutlery with sharp points in Model : the cutlery basket with the points down or in PNC : a horizontal position. Serial Number : • Do not keep the appliance door open with- out supervision to prevent to fall on it. Control panel www.zanussi.com...
Do not use detergent with this programme. Information for test institutes For all the necessary information for test performance. send an email to: info.test@dishwasher-production.com Write down the product number (PNC) that is on the rating plate. www.zanussi.com...
Water softener Water hardness adjustment German French mmol/l Clarke Level degrees degrees degrees (°dH) (°fH) 47 - 50 84 - 90 8.4. - 9.0 58 - 63 43 - 46 76 - 83 7.6 - 8.3 53 - 57 www.zanussi.com...
Page 6
Each time you press the programme button the level num- ber increases. 7. Press the on/off button to deactivate the Put 1 litre of water in the salt container (only appliance and to confirm the setting. for the first time). www.zanussi.com...
2. Set the rinse aid dispenser to the lowest position. If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. Set the water softener to the highest level. www.zanussi.com...
Page 8
• When the countdown is completed, the programme starts. Opening the door while the appliance operates If you open the door, the appliance stops. When you close the door, the appliance con- tinues from the point of interruption. www.zanussi.com...
Care and cleaning Warning! Before maintenance, Make a check regularly and, if necessary, deactivate the appliance and disconnect clean them. the mains plug from the mains socket. Dirty filters and clogged spray arms de- crease the washing results. www.zanussi.com...
The appliance does not start or it stops during With some problems, the end indicator operation. flashes intermittently to show an alarm Before you contact the Service, refer to the in- code. formation that follows for a solution to the problem. www.zanussi.com...
Page 11
• The released quantity of rinse aid is too • The quality of the rinse aid can be the much. Adjust the rinse aid selector to a low- cause. er position. • The quantity of detergent is too much. www.zanussi.com...
Help protect the environment and human municipal office. health and to recycle waste of electrical and • Discard correctly the packaging material. electronic appliances. Do not dispose Recycle the materials with the symbol www.zanussi.com...