Specifying The Relative Position/Esc - Citizen PD 22 PD-22 PD-22 Command Reference Manual

Specifying the relative position/ESC ¥
[ASCII]
[Decimal]
[Hexadecimal]
[Parameter]
[Description]
● Specifies the print start position of the next data as a relative position in dots.
● 'To specify by a relative position' means to specify the next print start position by the number of given rightward or
leftward dots, based on the print position immediately before this code.
● The number of dots is calculated on a 1/203 inch basis. 'n1' and 'n2' indicate the number of dots from a print position
used as the reference. Specify leftward moving with two's complement.
Number of dots = n1 + 256 × n2
−1440 ≤ (n1 + 256 × n2) ≤ 1440
● The number of dots and the values of 'n1' and 'n2' correspond as follows. (The values of 'n1' and 'n2' in the table are in
hexadecimal.))
● Values beyond the left margin or right margin will be ignored.
● Underline Specification (ESC-, FS-) by the moving area of ESC ¥ is processed as follows.
Type of underline
Left m
Left edge
position
Left margin
ESC ¥ n1
27 92 n1
1B 5C n1
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
Number of dots
1140
・
2
1
0
-1
2 -
3 -
・
-1440
specification
ESC-
FS-
argin Next p rinting
start p osition
n2
n2
n2
n1 n2
05 A0
・ ・
00 02
01
00
00 00
FF FF
FF FF
FF FD
・ ・
FA 60
Moving direction of ESC¥
Leftward
Not drawn
Not drawn
Current printing
position
DEF ABC
Negative d ire ction
Reference p
- 62 -
Rightward
Lines are drawn.
Not drawn
Next printing start
position
DEF
Positive direction
osition