Replacing The Power Supply - Gateway GT4015 Hardware Reference Manual

www.gateway.com

Replacing the power supply

Tips & Tricks
You need a Phillips screwdriver to replace
the power supply.
To replace the power supply:
Remove the side panel by following the instructions in
1
panel" on page 12.
Disconnect the power supply cables from all components (such as hard
2
drives, CD or DVD drives, and the system board), noting their locations and
orientation. (You will reconnect the cables after you install the new power
supply.)
Remove the three screws that secure the power supply to your computer.
3
Slide the power supply away from the back of your computer, then pull
4
it down and remove it.
Install the new power supply into the case, then install the three screws
5
to secure the power supply to the case.
Reconnect the power supply cables using your notes from
6
Replace the side panel by following the instructions in
7
panel" on page 14.
Replacing the power supply
"Removing the side
Screws
Step 2.
"Replacing the side
25