Adding Or Replacing A Cd Or Dvd Drive - Gateway GT4015 Hardware Reference Manual

www.gateway.com

Adding or replacing a CD or DVD drive

Tips & Tricks
You need a Phillips screwdriver to add or
replace a CD or DVD drive.
Important
The color and shape of your replacement
component's front cover may vary from
your original component.
Replace the side panel by following the instructions in
10
panel" on page 14.
Reconnect all external cables and the power cord.
11
Turn on your computer.
12
Open the BIOS Setup utility.
13
In the BIOS Setup utility, restore any settings that you wrote down in
14
Step 3.
Save all your settings and exit the BIOS Setup utility.
15
To add replace a CD or DVD drive:
Remove the side panel by following the instructions in
1
panel" on page 12.
Remove the front bezel by following the instructions in
2
front bezel" on page
If you are replacing an existing drive, disconnect the cables from the drive,
3
noting their locations and orientation. You will reconnect the cables after
you install the new component. (CD/DVD drive shown.) If you are installing
a new drive, go to Step
Adding or replacing a CD or DVD drive
13.
6.
"Replacing the side
"Removing the side
"Removing the
17