Replacing The System Board - Gateway 710XL User Manual

Chapter 11: Upgrading Your Computer
5
Slide the power supply up and away from the power supply brackets.
6
Install the new power supply into the case, then install the four retention
screws to secure the power supply to the case.
7
Reconnect the power supply cables using your notes from
power supply documentation for further instructions.
8
Close the case by following the instructions in
page

Replacing the system board

To replace the system board:
1
Remove the side panel by following the instructions in
panel" on page
2
For more stability, place your computer on its side. To avoid scratching
the case, place it on a towel or other non-abrasive surface.
3
Remove all of the add-in cards by following the instructions in
or replacing add-in cards" on page
216
196.
192.
www.gateway.com
"Closing the case" on
"Removing the side
206.
Step 3. See the
"Adding