Gateway 710XL User Manual page 13

Component
Power connector
Voltage switch
PS/2 mouse port
PS/2 keyboard port
USB ports
Serial port
Monitor ports
Audio jacks
Modem jack
Thumbscrews
Parallel port
Ethernet (network)
jack
Telephone jack
Icon Description
Plug the power cable into this connector.
Before turning on your computer, make sure that this switch
is in the correct position for the correct power available. The
switch is preset at the factory with the correct voltage for your
area.
In the United States, the utility power is supplied at a nominal
115 volts at 60 Hz. The power supply should always be set to
this when your computer is operating in the United States. In
other areas of the world, such as Europe, the utility power is
supplied at 230 volts at 50 Hz. If your computer is operating
in such an environment, move the switch to 230.
Plug a Personal System/2
Plug a PS/2 keyboard into this port.
Plug USB (Universal Serial Bus) devices (such as a USB
Iomega™ Zip™ drive, printer, scanner, camera, keyboard, or
mouse) into these ports. For more information, see
a printer, scanner, or other peripheral device" on page
Plug a serial device (such as a digital camera) into this port.
For more information, see
peripheral device" on page
Plug a monitor into one of these ports.
Plug a microphone, speakers, or headphones into these jacks.
Plug a modem cable into this jack.
Remove these screws before opening the case.
Plug a parallel device (such as a printer) into this port. For more
information, see
peripheral device" on page
Plug a 10/100 Ethernet network cable into this jack. For more
information, see
If your optional modem has a telephone jack, plug the cable
for a telephone into this jack.
www.gateway.com
®
(PS/2) mouse into this port.
"Installing a printer, scanner, or other
24.
"Installing a printer, scanner, or other
24.
"Learning about the Internet" on page
Back
"Installing
24.
56.
5