Fitting The Cover; Installation Sequence - Viessmann Vitocell 100-E Installation And Service Instructions Manual

Fitting the cover

1.
A
2.
Fig. 10
Viessmann logo
A
Making the connections on the heating water side
Any number of heating water buffer cylinders, type
SVPB, can be connected in series or in parallel. Pro-
vide connection pipes and air vent valves on site.
!
Please note
The thermal insulation must not come into con-
tact with naked flames.
Exercise caution when welding and brazing.
Permissible temperature
Permissible operating
pressure
Test pressure
Note
For location of connections, see page 7.
1. Connect all pipework with detachable fittings.
2. Install the flow line with an incline and fit an air vent
3. Check all connections for leaks after filling the cyl-
110 °C
6 bar (0.6 MPa)
9.6 bar (0.96 MPa)
valve at the highest point.
inder.

Installation sequence

15