Viessmann Vitocell 100-E Installation And Service Instructions Manual page 10

Installation sequence
Fitting the thermometer sensor (if supplied) ...
2. Guide the upper thermometer sensor through the
lifting eye, insert it into the clamping bracket as far
as it will go and tighten the wing nut.
Note
The cover strip is held in its vertical position by the
coiled capillaries. This is necessary for the remain-
der of the installation.
3. Route the thermometer sensor capillaries to the
back of the cylinder.
4. Undo the nuts.
5. Place the clamping system onto the threaded studs
and align.
Mounting the Vitotrans
Fig. 4
10
2.
1.
(cont.)
6. Tighten the nuts.
7. Depending on where the sensor is being fitted,
secure the thermometer sensor in the clamping
bracket or push as far as it will go into clamping
systems .
A
Push cylinder temperature sensor into the
clamping system as far as it will go.
Note
■ Never wrap insulating tape around the sensors.
When the thermal insulation is being fitted, the
■
cylinder temperature sensor leads are routed
outwards through the apertures (slots) in the rear
cover strip.