Configuring Other Vessels - Garmin GPSMAP 536 Owner's Manual

Configuring the Chartplotter
Select OK, and safely increase the speed of the boat. If the message
appears again, stop the boat and make sure the speed-sensor wheel
is not stuck. If the wheel turns freely, check the cable connections. If
you continue to get the message, contact Garmin Product Support.
fuel Capacity—enter the combined fuel capacity of all the engines
on your boat.

Configuring Other Vessels

To configure settings for boats other than your own, from the
Home screen, select Configure
NOTE: To configure AIS or DSC information for other boats, your
unit must be connected to an external AIS or DSC device.
aiS—turn AIS (Automatic Identification System) on or off. AIS
alerts you to area traffic by providing boat IDs, position, course,
and speed for boats that are within range and equipped with a
transponder. For more information concerning the use of AIS, see
page 23.
dSC—turn DSC (Digital Selective Calling) on or off.
aiS alarm—create a safe zone around your boat for collision
avoidance. The zone can be customized.
5
> Other Vessels.
To customize safe-zone settings:
From the Home screen, select
Alarm.
• range—change the measured radius of the safe-zone ring to
a specified distance from 500 ft. to 2.0 nm (or from 150 m to
3.0 km, or from 500 ft. to 2.0 mi).
• Time to (Safe Zone)—sounds an alarm if AIS or MARPA
determines that a target will intersect the safe zone within the
defined time interval (from 1 to 24 minutes).
• AIS Alarm—when On is selected, a message is displayed
("AIS: Dangerous Target") when a vessel enters the safe
zone. When Off is selected, the message will not be
displayed.
Configure > Other Vessels
GPSMAP 400/500 Series Owner's Manual
> AIS