Garmin 430 Basic Operations
Hide thumbs
Also See for 430:
- Pilot's manual (22 pages) ,
- Owner's manual (88 pages) ,
- Installation instructions manual (30 pages)
Advertisement
Quick Links
AOPA Air Safety Foundation
Garmin 430/530
Basic Operations
This printable version of the AOPA Air Safety Foundation Garmin 430/530 course
is a quick reference for VFR functions of these units.
The Air Safety Foundation reminds you to always Keep Your Head Up when
using your GPS in visual conditions. Pilots are always responsible for a safe
fl ight, including avoiding midair collisions.
CONTROLS
GNS 430
COM Power/
Volume Knob
COM Flip-fl op Key
VLOC Volume Knob
VLOC Flip-fl op Key
Large Left Knob
Small Left Knob
CDI Key
GNS 530
COM Flip-fl op Key
COM Power/
Volume Knob
VLOC Flip-fl op Key
VLOC Volume Knob
Large Left Knob
Small Left Knob
CDI Key
CONTROLS
COM Power/Volume Knob controls unit power and COM volume. Pressing it
momentarily disables automatic squelch control.
COM Flip-Flop Key swaps the active and standby COM frequencies. Press and
hold it to automatically tune the emergency frequency (121.5).
VLOC Volume Knob controls volume for the VOR/Localizer (VLOC). Pressing it
momentarily enables or disables the ident tone.
VLOC Flip-fl op Key swaps the active and standby VLOC frequencies.
Large Left Knob (COM/VLOC) tunes megahertz (MHz) values for the standby
COM or VLOC frequency.
Small Left Knob (COM/VLOC) tunes the kilohertz (kHz) values for the COM or
VLOC frequency. Pressing the small knob momentarily also toggles the tuning
cursor between the COM and VLOC frequency fi elds.
Range Key
Direct-To Key
CDI Key toggles the navigation source (GPS or VLOC) going to the external CDI
Enter Key
or HSI.
Clear Key
Range Key selects the map scale. The up arrow zooms out showing a larger
Large Right Knob
area. The down arrow zooms in showing a smaller area.
Small Right Knob
Direct-To Key allows you to enter a destination waypoint and then displays a
direct course to it.
Clear Key erases information or cancel an entry. Press and hold CLR to display
the Default Navigation Page.
Range Key
Enter Key approves an operation or completes data entry. It also confi rms
information, like during power on.
Direct-To Key
Clear Key
Large Right Knob (GPS) selects between the displayed page groups: NAV,
Enter Key
WPT, AUX or NRST. It also allows you to move the cursor about the page.
Large Right Knob
Small Right Knob (GPS) selects pages within a group listed above. Pressing it
Small Right Knob
momentarily displays the cursor.
Advertisement
Related Manuals for Garmin 430
Summary of Contents for Garmin 430
- Page 1 COM Flip-Flop Key swaps the active and standby COM frequencies. Press and hold it to automatically tune the emergency frequency (121.5). This printable version of the AOPA Air Safety Foundation Garmin 430/530 course is a quick reference for VFR functions of these units.
- Page 2 POWER ON USING VLOC The COM power/volume turns the unit on and sets the desired radio volume. The VLOC refers to tuning and navigating with VOR and localizer (LOC) self test screen will display briefl y. If the airplane has an Avionics Master switch, signals.
- Page 3 All the controls and indicators for the GPS are located on the Display Default NAV Page - On the right side of the panel. GNS 430, press and hold the CLR key for two seconds. The default NAV page SELECT DIRECT-TO is displayed.
- Page 4 (with “Activate?” highlighted) to navigate to that airport. The Map page will be displayed. LEARN MORE You can learn more about GPS safety and operation at the following web sites: AOPA Air Safety Foundation http://www.aopa.org/asf Garmin Aviation http://www.garmin.com/aviation/ Edition 2...