Calling An Ais Target - Garmin GPSMAP 536 Owner's Manual

The selection of a DSC channel is limited to those channels that are
available in all frequency bands: 6, 8, 9, 10, 13, 15, 16, 17, 67, 68,
69, 71, 72, 73, or 77.
NOTE: The default channel is 72. However, select
select a different channel from the list. If you select a different
channel, the chartplotter uses that channel for subsequent calls until
you call using a different channel.
To make an individual routine call:
1. While viewing a chart, press
DSC List.
2. Select the station to call from the list.
3. Select review > Call with
4. Select Send to send the information about the call to the radio.
5. On your Garmin VHF radio, select Call.
GPSMAP 400/500 Series Owner's Manual
Channel
MEnU > Other Vessels > DSC
radio.

Calling an AIS Target

When you connect your Garmin chartplotter to a Garmin VHF
NMEA 2000 compatible radio, you can use the chartplotter interface
to set up an individual routine call to an AIS target. For more
to
information on selecting a channel other than the default channel
(Channel 72), see
To make an individual routine call to an AIS target:
1. While viewing a chart, use the
target .
>
2. Select AIS Vessel
3. Select Send to send the information about the call to the radio.
4. On your Garmin VHF radio, select Call.
Using Digital Selective Calling
page 66.
rocker to select an AIS
> Call with radio.