Installing The Batteries; Turning The Colorado On And Off - Garmin Colorado 300 Owner's Manual

G S
ettInG tarted

Installing the Batteries

The Colorado operates on two AA batteries (not
included). You can use alkaline, NiMH, or lithium
batteries.
To install the batteries:
1. Remove the battery
cover by lifting the latch
and sliding the cover
off the back of the
Colorado.
2. Insert the batteries,
observing the diagram
molded into the battery
compartment.
3. Replace the battery cover
by sliding it back onto the
Colorado and fastening
the latch.
NOTE: Remove batteries when you do not plan to use
the Colorado for several months. Stored data is not lost
when batteries are removed.

Battery cover
Latch
Battery compartment

Turning the Colorado On and Off

To turn the Colorado on:
Press and hold the
logo appears on the Colorado.
To turn the Colorado off:
Press and hold the
The first time you turn the Colorado on, the GPS
receiver must collect satellite data and establish its
current location.
NOTE: To receive satellite signals, you must be
outdoors and have a clear view of the sky.
When you turn the Colorado on for the first time, the
Colorado sequences through several setup screens:
language selection, time zone, and daylight saving time
mode. For complete information on initial Colorado
setup, see the Colorado Series Quick Start Guide.
CAUTION: Certain settings on the Colorado
can shorten battery life. See
information on battery life.
Power key until the Garmin
Power key.
page 37 for complete
Colorado Series Owner's Manual
™