Table of Contents
Advertisement
Intel® Server System M20NTP1UR - System Integration and Service Guide
Align the Pin 1 indicator of processor carrier clip with one of the diagonally cut corners on the
•
base of the heat sink. Or (If present) look for the Pin 1 indicator on the corner of the heat sink
label.
Gently press down the heat sink onto the processor carrier clip until it clicks into place.
•
Ensure all four heat sink corners are securely latched to the carrier clip tabs.
•
2.3.2
PHM Installation
If installed, remove the plastic cover from the processor socket.
Caution: Do not touch the socket pins. The pins inside the processor socket are extremely sensitive. A
damaged processor socket may produce unpredictable system errors.
•
Remove the protective socket cover by squeezing the finger grips (see Letter "A") and pulling
the cover up (see Letter "B").
•
Ensure the socket is free of damage or contamination before installing the PHM.
Caution: If debris is observed, blow it away gently. Do not remove it manually, such as with tweezers.
1. Orient and position the PHM over the processor socket (See
Align the Pin 1 indicators of the processor carrier clip and processor with the Pin 1 indicator
•
on the socket assembly bolster plate.
24
Figure 14. Processor Socket Cover Removal
Figure 15. PHM Alignment with Processor Socket Assembly
Figure
15)
Advertisement
Table of Contents
