Using The Rollover Protection System (Rops) - Toro Z Master Professional 7500-D Series Operator's Manual

Using the Rollover
Protection System (ROPS)
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
WARNING
There is no rollover protection when the roll
bar is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e., branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
Lowering the Roll Bar
Important:
Lower the roll bar only when
absolutely necessary.
1. To lower the roll bar, apply forward pressure to
the upper part of the roll bar.
2. Pull both knobs out and rotate them 90 degrees
so they are not engaged
3. Lower the roll bar to the down position
10).
(Figure 10).
(Figure
1. Upper part of the roll bar
2. Knob in the latched
position
3. Pull the knob to unlatch.
Raising the Roll Bar
Important:
Always use the seat belt with the roll
bar in the raised position.
1. Raise the roll bar to the operating position and
rotate the knobs until they move partially into
the grooves (Figure
2. Raise the roll bar to the full upright position while
pushing on the upper roll bar so that the pins
snap into position when the holes align with the
pins (Figure 11).
3. Push on the roll bar and ensure that both pins
are engaged (Figure
1. Engaged
19
Figure 10
4. Rotate the knob out 90°
to hold it in the unlatched
position.
5. Knob in the unlatched
position
11).
11).
Figure 11
2. Partially engaged—do not
operate the machine with
the ROPS in this position.
g225804
g008619