Cleaning And Maintenance - Waring WWCM180E/K Manual

Single and double waffle cone makers
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
INSTRUCTIONS FOR MAKING WAFFLE BOWLS
The waffle bowl mold/pusher is available as an optional
accessory. It is best to create a waffle bowl immediately after the
baking cycle while the flat waffle is still hot. A cool waffle bowl is
difficult to create without breaking. Caution: Take care during
this process as the waffle will be hot. Once the waffle cone
maker beeps and the ready light illuminates, open the grid and
remove the hot, flat waffle. Place the waffle bowl mold tool on a
flat surface. Center the flat waffle in the bowl mold. Gently use
the pusher to push the flat waffle fully into the mold, creating a
bowl. Be careful not to push so hard that you break the waffle
bowl. Leave the waffle bowl like this, between the mold and the
pusher, to cool for about 20 seconds. Remove the pusher and
carefully remove your waffle bowl.
Once you have finished baking, switch the toggle switch to the
OFF position and remove plug from electrical outlet. Leave top lid
open and allow grids to cool before cleaning (details follow).

CLEANING AND MAINTENANCE

Once you have finished baking, switch the toggle switch to the
OFF position and remove plug from electrical outlet. Leave top lid
open and allow grids to cool before cleaning.
Never take your waffle cone maker apart for cleaning. Simply
brush crumbs from grooves and absorb any excess cooking
oil by wiping with a dry cloth or paper towel. You may clean the
grids by wiping with a damp cloth to prevent staining and sticking
from batter or oil buildup.
Be certain grids have cooled completely before cleaning.
If batter adheres to plates, simply pour a little cooking oil onto
the baked batter and let stand approximately 5 minutes, allowing
batter to soften for easy removal.
To clean exterior, wipe with a soft dry cloth. Never use an
abrasive cleanser or harsh pad. NEVER IMMERSE CORD, PLUG
OR UNIT IN WATER OR OTHER LIQUIDS.
The CAC121 rolling and forming tool and CAC122 bowl mold
and pusher should be hand-washed only. They are not
dishwasher safe.
Any other servicing should be performed by an authorized
service center.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wwcm200e/k

Table of Contents