Table of Contents
Advertisement
2
Replaceable Parts
Ordering Information
To order a part, do the following:
1. Determine the part number.
2. Determine the quantity required.
3. Mail this information to the nearest Agilent Technologies office or, in the U.S., call the hot-line number listed in the following section.
To order a part not listed in the replaceable parts lists, mail the following information to the nearest Agilent Technologies office.
1. the instrument model number
2. the serial number and options, if any (see rear panel)
3. a description of the part
4. a description of the part's function
5. the quantity required
Order Parts Fast
When you have gathered the information required to place an order, go to the Agilent Technologies Technical Support website:
http://www.agilent.com/find/techsupport
Shipping a Defective Assembly Back to Agilent Technologies
1. When you receive the rebuilt/exchange assembly, be careful not to damage the box and shipping hardware in which it was shipped. You
will use that box and shipping hardware to return the defective assembly. The box you receive should contain the following:
•
the rebuilt assembly
•
an exchange assembly failure report
•
a return address label
2. Complete the failure report.
3. Place the failure report and the defective assembly in the box. Be sure to remove the enclosed return address label.
4. Seal the box with tape.
If you are inside the United States, stick the pre-printed return address label over the label that is already on the box and return the box to
Agilent Technologies. (Agilent Technologies pays postage on boxes mailed within the United States.)
If you are outside the United States, do not use the return address label; instead, address the box to the nearest Agilent Technologies sales
and service office.
Agilent N5161A/62A/81A/82A/83A MXG Signal Generators Service Guide
2-1
Advertisement
Table of Contents
Troubleshooting
