Advertisement
Circuit Breaker Protection
When the Circuit Breaker automatically stops the motor due to overloading, follow the below steps:
1
Switch off to reset the Circuit Breaker.
2
Unplug and disassemble the parts by reversing steps on "To Assemble" from 2-5 of page EN5 to remove
ingredients in the Head.
3
Assemble the parts again and continue grinding meat by pushing the meat slowly.
:
Note
• Circuit Breaker may not reset over 40 °C room temperature. In that case please move appliance to the room
temperature under 35 °C and wait until it is cooled down.
Troubleshooting
Please check following points before arranging for service.
Ensure to turn off the appliance and the power supply before taking the actions in the table below:
Problems
The appliance does not run after the
Switch is turned on.
The appliance stopped suddenly.
The Switch does not turn.
The Feed Screw is not turning even
the motor is on.
Specifi cations
Model No.
Power Supply
Power Consumption
Dimension (Approx.)
W × D × H
Mass (Approx.)
Meat_Grinder_MK-GJ1700.indb 9
Meat_Grinder_MK-GJ1700.indb 9
Causes
The Plug is not inserted into an outlet. Insert the Plug fi rmly into an outlet.
The Circuit Breaker Protection is
activated.
• Prohibited ingredients are used.
• The volume of ingredients is too
large.
• The ingredients are too hard.
This is a malfunction.
MK-GJ1700
220 - 240 V
240 - 290 W
172 mm × 327 mm × 398 mm
4.0 kg
Actions
See "Circuit Breaker Protection".
Please contact the Service Centre for repair.
MK-GJ1500
50 - 60 Hz
220 - 250 W
172 mm × 327 mm × 392 mm
3.7 kg
EN9
11/14/2018 10:32:45 AM
11/14/2018 10:32:45 AM
Advertisement
