2 Specifications <Caution> • Do not grind too hard meat. If the grinder gets stuck, do not force meat into it. • You may feel the feed screw vibrating during use. It is not a trouble. Do not over tighten the locking knob. •...
5 Troubleshooting Guide 5.1. SYMPTOM : A.C. motor interrupted when feeding meat (overloaded). Causes Remedy Too hard meat being fed. Take out the hard meat. Too much meat being fed at once. Reduce the meat feed rate. Used for too long continuously. Follow the specified operating time.
6 Disassembly and Assembly Instructions For assembly, refer to the Assembly Instructions, and perform the procedures in the opposite order of disassembly. 6.1. Detach motor housing(right) 1. Turn the locking knob counterclockwise to remove it. 2. Lay the grinder with its left side down. 3.
Page 12
6.3. Removing the gear case cover, gears and gear case. 1. Remove the two gear case cushions. 2. Remove the four lock screws and detach the gear case cover. 3. Take out the bearing B from inside the gear case cover. •...
8 Exploded View and Replacement Parts List 8.1. PARTS LOCATION...
Page 15
REPLACEMENT PARTS LIST Notes:Important safety notice • Components identified by mark have special characteristics important for safety. • " When replacing any of these components use only manufacturer's specified parts." MODEL No.MK-ZG1500BTN Pcs/Set Safety Ref. No. Part No. Part Name & Description...