Setting Up And Maintaining Schedules; Creating A Schedule - Trane Tracer TD7 Installation, Operation And Maintenance Manual

Setting Up and Maintaining Schedules

Tracer TD7 supports three types of schedules: analog, binary, and multistate. A maximum of three
schedules can be created. Each schedule can contain up to 10 members, 10 events, and 25
exceptions.
Schedules are created on a series of "events" that occur on each day of the week. An event is a
change in a value at a specific time that can occur during any day of the week.
Each day is independent of the others and always begins with the schedule default value. The
schedule default value is applied to each day of the week and is the value that the schedule defaults
to at 12:00 a.m. for any given day.
Note: Scheduling requires installation of UC600 version 3.0 or higher firmware.

Creating a Schedule

1. Navigate to the Settings screen, then touch the Schedules button.
2. Under Inactive Schedules, touch a schedule
Figure 44. Schedules screen (no active schedules)
3. Touch the Edit Schedule button
BAS-SVX50F-EN
(Figure 44).
(Figure 45, p. 52), then touch the Edit Members button.
Settings
51