Setting Schedule Defaults And Adding Events; About The Schedule Default Value; Setting Schedule Defaults - Trane Tracer TD7 Installation, Operation And Maintenance Manual

Settings

Setting Schedule Defaults and Adding Events

After creating a schedule and selecting the members, the next step is to set schedule defaults and
add weekly events. An event is defined as a time-value pair.
To access the daily view screen, touch the day of the week inside of the schedule in which you want
to add events.

About the Schedule Default Value

•
•
•
•

Setting Schedule Defaults

8. Open the schedule that you created in the above section,
9. To edit the schedule default value, touch the Edit Schedule button
Figure 49. Edit Schedule screen
10. Select a new default value, then touch Save. You are returned to the Edit Schedule screen.
54
The initial default value for the three types of schedules are:
– Analog = 0
– Binary = Off/False
– Multistate = State 2 (based on Occupancy Request where State 2 is unoccupied)
The default value can be changed. (Changing the default value does not affect the actual
configured default value of the point.)
The default value goes into effect each day at 12:00 a.m, provided that no other event takes
control at that time. It remains in effect until the first event of the day occurs or until 12:00 a.m.
the next day.
If the schedule member is a multistate point, the state text of the first selected member is used
in all of the TD7 Schedule screens.
When a schedule is created, the only event in the schedule is the schedule default value. This
value occurs every day at midnight and cannot be removed. If the schedule default value is
edited, the value applies to each day of the week in the schedule.
the Edit Default button (Figure 49). The Edit Default screen opens
Edit Default
"Creating a Schedule".
(Figure 48, p. 53), then touch
(Figure 50, p. 55).
BAS-SVX50F-EN