Husqvarna 45-05082-669 Owner's Manual page 9

Table of Contents

Advertisement

STEP 8: (SEE FIGURE 6)
• Route the wire harness along the left side of the tractor.
• Install two clamps onto the wire harness and attach
them to the bolts in the top cover of the winch using
two 5/16" nylock nuts.
CLAMPS
FIGURE 6
STEP 9: (SEE FIGURE 7)
• Install a 3/8" hex nut all the way onto the 3/8" x 1-1/2"
bolt in the L.H. side plate.
• Install a clamp onto the the wire harness, just in front
of where the two wires separate from the corrugated
tubing. Attach the clamp to the 3/8" x 1-1/2" bolt using
a 3/8" nylock jam nut.
FIGURE 7
STEP 10: (SEE FIGURE 8)
• Connect the wire harness to the winch motor, making
sure the connectors snap firmly together.
• Attach the wire harness to the rear of the side plate
using a plastic tie.
FIGURE 8
5/16" NYLOCK NUTS
LEFT SIDE VIEW
3/8" HEX NUT
CLAMP
3/8" NYLOCK JAM NUT
LEFT SIDE VIEW
CONNECTORS
PLASTIC TIE
LEFT SIDE VIEW
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
STEP 11: (SEE FIGURE 9)
Remove the bolt, if present, in the hole directly behind
the brake rod on the left side of the tractor frame.
• Attach the L.H. Hanger Bracket (tube facing out) to the
hole using a 5/16" x 3/4" self threading bolt.
• Install a shoulder bolt into the hole that is 9-1/2" to the
rear of the bolt you just installed. Secure it with a 3/8"
flange nut on the inside of the frame.
BRAKE ROD
L.H. HANGER
BRACKET
FIGURE 9
STEP 12: (SEE FIGURE 10)
Remove the bracket, if present, from the hole directly
behind the end of the brake rod on the right side of
the tractor frame. Store the bracket and bolt.
• Attach the R.H. Hanger Bracket to the hole using a
5/16" x 3/4" self threading bolt.
• Install a shoulder bolt into the hole that is 9-1/2" to the
rear of the bolt you just installed. Secure it with a 3/8"
flange nut on the inside of the frame.
5/16" x 3/4" SELF
THREADING BOLT
SHOULDER
BOLT
FIGURE 10
9
5/16" x 3/4" SELF
THREADING BOLT
SHOULDER
BOLT
3/8" FLANGED NUT
LEFT SIDE VIEW
RIGHT END OF
BRAKE ROD
R.H. HANGER
BRACKET
3/8" FLANGED
NUT
RIGHT SIDE VIEW

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

45-04912-669

Table of Contents