Husqvarna 45-05082-669 Owner's Manual page 10

THIS SECTION IS FOR TRACTORS WITH A
MANUAL ATTACHMENT CLUTCH
If your tractor has an electric attachment clutch go to
step 18 on page 12.
STEP 13: (SEE FIGURE 11)
• Attach the pulley (long end of hub facing down) and
the large 3/8" spacer to the clutch frame. Use a 3/8" x
3-1/4" hex bolt, a 3/8" washer, a 3/8" lock washer and a
3/8" hex lock nut.
• Install a tensioning chain through the hole shown and
then insert a 3/32" hairpin cotter into the 4th link.
• Attach the chain to the spring on the lower idler arm.
3/8" HEX LOCK NUT
3/8" LOCKWASHER
3/8" WASHER
LARGE 3/8" SPACER
3/32" HAIRPIN COTTER
IN 4TH LINK
FIGURE 11
STEP 14: (SEE FIGURE 12)
• Attach the cable bracket to the double hole in the
clutch frame as shown, using a 5/16" x 3/4" carriage
bolt and a 5/16" nylock nut. Place the bolt in the front
hole of the bracket and in the end of the hole closest
to the pulley. Do not tighten yet.
5/16" NYLOCK
NUT
FIGURE 12
PULLEY
(long end of
hub down)
3/8" x 3-1/4"
HEX BOLT
TENSIONING
CHAIN
5/16" x 3/4"
CARRIAGE BOLT
CABLE
BRACKET
10
STEP 15: (SEE FIGURE 13)
• Attach each rear pulley frame bracket to the inside of
the clutch/idler assembly using two 5/16" x 3/4" hex
bolts, 5/16" washers and 5/16" nylock nuts.
• Attach each front pulley frame bracket to the inside
of the clutch/idler assembly using two 5/16" x 1" hex
bolts, four 5/16" washers and two 5/16" nylock nuts.
5/16" x 3/4"
HEX BOLT
5/16" WASHER
FIGURE 13
STEP 16: (SEE FIGURE 14)
• Two different length drive belts are included with your
snow thrower. Use the longer, 56" drive belt (#48138)
on tractors with manual attachment clutches.
• Slightly loosen the hex bolt next to the flat idler pulley.
Install the drive belt down between the hex bolt and the
flat idler pulley with the flat side of the belt against the
pulley. Retighten the hex bolt.
• Loop the belt around the large V-pulley, placing it
between the V-pulley and the hex bolt next to the pulley.
Place the belt to the inside of the other flat idler pulley.
HEX BOLTS
(#48138)
DRIVE BELT
FIGURE 14
Did you select the correct drive belt for your
STOP
tractor? Using the wrong length belt may
cause premature bearing or belt failure.
5/16" x 1"
(2) 5/16"
HEX BOLT
WASHERS
5/16"
NYLOCK
NUT
FLAT IDLER
PULLEYS