Husqvarna 45-05082-669 Owner's Manual page 16

STEP 32: (SEE FIGURE 30)
• Remove the plastic tie from the cable.
• Place the winch cable loop between the lift links and
install a 1/2" x 1" clevis pin through the lift links and
the cable loop from the side shown. Secure it with a
5/64" hairpin cotter.
FIGURE 30
STEP 33: (SEE FIGURE 31)
• Check to make sure the auger belt is still properly
seated around the snow thrower's auger pulley and
idler pulleys.
AUGER PULLEY
TWIST
1/4 TURN
IDLER
PULLEY
FIGURE 31
5/64" HAIRPIN
COTTER
WINCH CABLE
LIFT LINK
1/2" x 1"
CLEVIS PIN
LIFT STOP BRACKET
VIEWED FROM RIGHT SIDE
TWIST
1/4 TURN
IDLER
PULLEY
INSTALLING THE AUGER BELT
STEP 34: (SEE FIGURE 32)
• Swing the lower idler arm over to the left side.
• Slightly loosen the belt keeper bolts located beside
the idler arm V-pulley and the rear V-pulley.
• Place the auger belt around the rear V-pulley and
between the two pulleys on the idler arm. The "V"
side of the belt must be seated in the grooves of the
V-pulleys.
• Retighten the two keeper bolts.
LEFT SIDE
OF TRACTOR
NUT
KEEPER
BOLT
FIGURE 32
BELT ROUTING DIAGRAM
16
KEEPER
BOLT
IDLER ARM
FLAT PULLEY
IDLER ARM V-PULLEY
VIEWED FROM LEFT SIDE
ENGINE PULLEY