Husqvarna 45-05082-669 Owner's Manual page 11

STEP 17: (SEE FIGURE 15)
• Find the cable clip that is attached to the left side
of the tractor frame underneath the footrest. Open
the clip and remove the mower clutch cable. Do not
remove the clip from the tractor frame. The cable
reattaches to the clip when using the mower deck.
• Move the attachment clutch lever on the dash panel to
the disengaged position.
• Place the clutch/idler assembly on the floor on the left
side of the tractor.
• Attach the tractor's mower clutch cable to the cable
bracket on the clutch/idler assembly. Secure the cable
housing guide (groove down) to the cable bracket
using the original collar and retainer spring.
• Place a 1/4" spacer on the welded pin on the idler
arm. Hook the end of the clutch cable spring over the
pin and secure it with a 1/4" washer and a 5/64" hair
cotter pin.
• Align cable bracket with welded pin and tighten the
nut assembled in step 14.
5/64" HAIR
COTTER PIN
TRACTOR'S
CLUTCH CABLE
CABLE
BRACKET
FIGURE 15
ATTACH CLUTCH IDLER ASSEMBLY TO TRACTOR
STEP 18: (SEE FIGURE 16)
• Attach the clutch/idler assembly to the tractor frame.
Hook the notched rear pulley frame brackets onto the
two shoulder bolts assembled to the outside of the
tractor frame. Lift the front of the assembly and attach
it to the R.H. and L.H. hanger brackets using two pivot
lock pins and 1/8" hairpin cotters.
• Loosely attach the mower clutch cable to the left side
of the tractor frame with a nylon tie. Do not pull the
nylon tie completely tight. The cable may need to be
removed from the nylon tie when using the mower
deck.
1/4" WASHER
1/4" SPACER
PIVOT LOCK PIN
(use this hole)
L.H. HANGER
BRACKET
FIGURE 16
STEP 19: (SEE FIGURE 17)
• Assemble the drive belt onto the engine pulley, routing
it through the engine pulley belt keepers.
HINT: You may need to remove the belt from the large
pulley on the clutch/idler assembly in order to assemble
it onto the engine pulley. When re-assembling the belt
onto the large pulley, be sure the belt is between the large
pulley and the hex bolt next to it.
• Go to step 26 on page 14.
LEFT SIDE
OF TRACTOR
ENGINE
PULLEY
FIGURE 17
11
1/8" HAIRPIN
NYLON TIE
COTTER
SHOULDER
BOLT
MOWER
CLUTCH
CABLE
VIEWED FROM LEFT SIDE
HEX BOLT
ENGINE
FLAT IDLER
PULLEY
PULLEY
BELT KEEPERS
VIEWED FROM UNDERNEATH
LARGE
PULLEY