Husqvarna 45-05082-669 Owner's Manual page 13

STEP 24: (SEE FIGURE 22)
• Attach the clutch/idler assembly to the tractor frame.
Hook the notched rear pulley frame brackets onto the
two shoulder bolts assembled to the outside of the
tractor frame. Lift the front of the assembly and attach
it to the R.H. and L.H. hanger brackets using two pivot
lock pins and 1/8" hairpin cotters.
PIVOT LOCK PIN
(use second hole)
FIGURE 22
L.H. HANGER
SHOULDER
BRACKET
BOLT
1/8" HAIRPIN
COTTER
VIEWED FROM LEFT SIDE
STEP 25: (SEE FIGURE 23)
• Assemble the drive belt onto the engine pulley. You
may need to remove the belt from the large pulley on
the clutch/idler assembly in order to assemble it onto
the engine pulley. When re-assembling the belt onto
the large pulley, be sure the belt is between the large
pulley and the hex bolt next to it.
• Place tension on the belt by pulling the left side
tensioning chain out as far as the 3/32" hairpin cotter
that was installed in the chain in step 19 will allow.
Secure the chain in this position by inserting a 1/8"
hairpin cotter through the chain.
NOTE; To prevent the chain from dragging on the
ground, loop the end of the chain though the pivot lock
pin. Refer to figure 33 on page 17.
• Go to step 26 on page 14.
LEFT SIDE
OF TRACTOR
HEX BOLTS
TENSIONING
CHAIN
1/8"
HAIRPIN
COTTER
ENGINE
PULLEY
FIGURE 23
13
LARGE
PULLEY
FLAT IDLER
PULLEY
VIEWED FROM UNDERNEATH