Husqvarna 45-05082-669 Owner's Manual page 15

STEP 29: (SEE FIGURE 27)
• Coat the top of the ring around the discharge opening
with general purpose grease.
• Place the discharge chute (facing forward) onto the
ring. Place the anti-rotation bracket on top of the chute
flange, aligning it with the holes on the right hand side
of the flange. Attach the three chute spacers and chute
keepers to the bottom of the flange using six 1/4" x 1"
hex bolts, 1/4" flat washers and 1/4" flanged lock nuts.
Tighten carefully so that the nuts are snug but do not
dig into the plastic chute keepers.
• Position the crank rod spiral (see figure 26 on page
14) so that it does not rub against the bottoms of the
notches in the chute flange. Tighten the nuts.
• Turn the crank rod to check if the chute rotates freely.
If not, loosen the bolts and nuts that attach the chute
to the flange by 1/4 turn each.
• Secure the control cables to the crank rod support
tube using a nylon tie.
1/4" x 1"
HEX BOLT
1/4" FLAT
WASHER
GREASED
SURFACE
CHUTE SPACER
CHUTE KEEPER
1/4" FLANGED
LOCK NUT
FIGURE 27
ANTI-ROTATION
BRACKET
FLANGE
RIGHT SIDE VIEW
15
ATTACHING SNOW THROWER TO TRACTOR
STEP 30: (SEE FIGURE 28)
• Place the snow thrower on a flat, level surface.
• Extend the auger belt out behind the snow thrower,
leaving the belt assembled to the snow thrower pulleys.
• Roll the tractor up behind the snow thrower, centering
it between the snow thrower's mounting plates.
• Lift up on the crank rod support tube to raise the
rear of the snow thrower and align the notches in the
mounting plates align with the shoulder bolts in the
tractor's side plates. Roll the tractor forward, guiding
the shoulder bolts into the notches.
• Install the two 1/2" x 3/4" clevis pins and 1/8" hairpin
cotters to secure the snow thrower to the tractor.
1/8" HAIRPIN
COTTER
1/2" x 3/4"
CLEVIS PIN
FIGURE 28
STEP 31: (SEE FIGURE 29)
• Connect the terminals of the wire harness to the limit
switch terminals on the snow thrower, making sure they
snap firmly together.
WIRE HARNESS
TERMINALS
LIMIT SWITCH
TERMINALS
FIGURE 29
DO NOT
REMOVE
PLASTIC TIE
RIGHT SIDE VIEW
RIGHT SIDE VIEW