Soft top (Cabriolet)
86
Removing
Bolts on the AIRCAP draught stop between the
head restraints in the rear compartment
Use the 4 mm hex-socket wrench to turn
X
the bolts on both sides anti-clockwise by
about 90° and loosen them.
Pull the bolts out of the brackets on the
X
head restraints.
Pull the AIRCAP draught stop out of the
X
guide rails in the direction of the arrow.
Make sure that you pull the AIRCAP draught
stop forwards slightly when doing so.
Fitting
Keeping the AIRCAP draught stop horizon-
X
tal, guide it into the slot between the head
restraints in the direction of the arrow with
both racks straight down.
Push the AIRCAP draught stop down until
X
the bolts are at the same height as the
brackets on the head restraints.
Insert the bolts into the brackets on both
X
sides.
Tighten the bolts with the 4 mm hex-socket
X
wrench until they engage.
The markings on the bolts are vertical.