Mercedes-Benz E-Class 2010 Owner's Manual page 209

Menus and submenus
206
In countries where daytime driving lights are
a legal requirement, On is the factory setting.
Switch off the engine.
X
Press the = or ; button on the steer-
X
ing wheel to select the Settings menu.
Press the : or 9 button to select the
X
Light submenu.
Press the a button to confirm.
X
Press the : or 9 button to select the
X
Daytime driving lights: function.
You will see the selected setting: on or
off.
Press the a button to save the setting.
X
Activating/deactivating the Intelligent
Light System
When you activate the Intell. Light Sys‐
tem: function, you activate the following:
motorway mode
R
active light function
R
cornering light function
R
extended range foglamps
R
Press the = or ; button on the steer-
X
ing wheel to select the Settings menu.
Press the : or 9 button to select the
X
Light submenu.
Press the a button to confirm.
X
Press the : or 9 button to select the
X
Intell. Light System: function.
You will see the selected setting: on or
off.
Press the a button to save the setting.
X
If you set the dipped-beam headlamps for
driving on the right/left (
Light submenu of the multifunction display
shows the Intell. Light System: Sys‐
tem inoperative Inactive for left-
side traffic or Intell. Light System:
System inoperative Inactive for
right-side traffic message instead of
the Intell. Light System: function.
page 206), the
Y
Setting the dipped-beam headlamp for
driving on the right/left
This function is only available on vehicles with
the Intelligent Light System.
You can use this function to switch between
symmetrical and asymmetrical dipped-beam
headlamps ( page 157).
Y
If you set the dipped-beam headlamps for
driving on the right/left, motorway mode and
the extended range foglamps are not availa-
ble.
You can only set the dipped-beam headlamps
for driving on the right/left when stationary:
Press the = or ; button on the steer-
X
ing wheel to select the Settings menu.
Press the : or 9 button to select the
X
Light submenu.
Press the a button to confirm.
X
Press : or 9 to select the Dipped
X
headl. Setting for: function.
You will see the selected setting: Right-
hand drive or Left-hand drive.
Press the a button to save the setting.
X
You can also have the dipped-beam head-
lamps set for driving on the right/left at a
qualified specialist workshop, e.g. a
Mercedes-Benz Service Centre.
Further information (
( page 157).
Y
Switching Adaptive Highbeam Assist on/
off
Press the = or ; button on the steer-
X
ing wheel to select the Settings menu.
Press the : or 9 button to select the
X
Light submenu.
Press the a button to confirm.
X
Press the : or 9 button to select the
X
Adaptive Main-beam Assist: function.
You will see the selected setting: Activa‐
ted or Deactivated.
Press the a button to save the setting.
X
page 106) and
Y