Mercedes-Benz E-Class 2010 Owner's Manual page 281

Flat tyre
278
Make sure pressure release screw F on
X
pressure gauge G is fully closed.
Screw filler hose D onto valve E.
X
Insert connector A into the cigarette
X
lighter socket (
socket in your vehicle (
Turn the key to position 1(
X
the ignition lock.
Press on/off switch ? on the electric air
X
pump to I.
The electric air pump is switched on. The
tyre is inflated.
i
First, TIREFIT is pumped into the tyre. The
pressure can briefly rise to approximately
500 kPa (5 bar/73 psi).
Do not switch off the electric pump dur-
ing this phase.
Let the electric pump run for five minutes.
X
The tyre should then have attained a pres-
sure of at least 180 kPa (1.8 bar/26 psi).
!
Do not operate the electric air pump for
longer than eight minutes at a time without
a break. It may otherwise overheat.
The air pump can be operated again once
it has cooled down.
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) has been achieved, see
( page 279).
Y
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) has not been achieved, see
( page 279).
Y
page 252) or into a 12 V
Y
page 253).
Y
page 135) in
Y
TIREFIT kit version 2
Pull connector ? with the cable and hose
X
A out of the housing.
Screw hose A onto flange B of TIREFIT
X
sealant filler bottle :.
Place TIREFIT sealant filler bottle : head
X
downwards into recess ; of the electric
air pump.
Remove the cap from valve C on the faulty
X
tyre.
Screw filler hose D onto valve C.
X
Insert connector ? into the cigarette
X
lighter socket ( page 252) or into a 12 V
Y
socket in your vehicle (
Turn the key to position 1(
X
the ignition lock.
Press on/off switch = on the electric air
X
pump to I.
The electric air pump is switched on. The
tyre is inflated.
page 253).
Y
page 135) in
Y