Installing The Weights - Toro 78490 Operator's Manual

2
1
Figure 19
1. Bolt for spring
2. Jam nut
6. Install the spring onto the tensioner pulley arm hook
(Fig. 20).
7. Install the skid plate (Fig. 18).
3
m–6092
3. 2 in.
14
7
6
4
3
6
Figure 20
1. Tensioner spring
2. Bolt for spring
3. Bagger tensioner pulley
4. Bagger pulley

Installing the Weights

Note: There are left hand and right hand weights and
weight brackets (Fig. 22).
Caution
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition
which could result in a loss of control.
Install the front weights.
1. Remove the two outside bolts that connect the front
floorpan to the carrier frame (Fig. 21). Save this
hardware.
2. Remove the 4 bolts and washers that hold the front
floorpan to the front frame (Fig. 21). Save this
hardware.
2
1
5
1
m–6004
5. Bagger belt
6. Clutch drive pulley
7. Clutch