Tightening All Mounting Bolts - Toro 78490 Operator's Manual

4
4
5
2
Figure 13
1. Bagger mounting bracket
2. Bolt, 5/16 x 3/4 in.
3. Flange nut, 5/16 in.
6. Install the bottom of the rear heat shield to the rear
bumper (Fig. 6).
7. Install the bagger mounting bracket to the rear heat
shield and engine guard strap with 2 bolts (5/16 x 1 in.)
and 2 flange nuts (5/16 in.) (Fig. 14).
8. Repeat for the opposite side (Fig. 14).
1
3
1
m–6028
4. Bumper
5. Flat washers, 5/16 in.
11
4
2
6
4
1
Figure 14
1. Bagger mounting bracket
2. Bolt, 5/16 x 1 in.
3. Flange nut, 5/16 in.

Tightening all Mounting Bolts

Important Use the torque specifications in the
following table when tightening the mounting bolts.
Size of mounting bolts
All 5/16 in. bolts
All 3/8 in. bolts
All 1/4 in. bolts
The following steps are the correct sequence to tighten the
the bagger mounting brackets when all fasteners are in
place.
1. Tighten the bagger mounting bracket to the rear bumper
(Fig. 13). See torque table.
2. Tighten the bagger mounting bracket to the upper rear
heat shield and engine guard strap (Fig. 14). See torque
table.
3. Tighten the bagger mounting bracket to the side of the
rear bumper (Fig. 12). See torque table.
3
1
5
m–6029
4. Rear heat shield
5. Engine guard strap
6. Rear bumper
Torque
230 in.–lb. (26 N m)
35 ft.–lb. (48 N m)
100 in.–lb. (11 N m)