Dremel 8260 Operating/Safety Instructions Manual page 16

reduce the risk of starting the tool accidentally.
not to cover the air vents with your
hand. This blocks the air flow and
causes the motor to overheat.
Slide "On/Off" Switch
The tool is switched "ON" by the slide
switch 7 located on the topside of the
motor housing.
TO TURN THE TOOL "ON", slide the
switch button forward.
TO TURN THE TOOL "OFF", slide the
switch button backward.
Learn the Speeds
After the tool has been turned off:
- If you turn it back on within 5
minutes, the tool will turn on at its
last set speed setting.
- If turned on after 5 minutes, the tool
will turn on at its default speed
setting of 15,000 RPM.
Dremel App Connectivity
- Download the Dremel App to your
iOS or Android device from the App
Store or Google Play.
- Install the Dremel App on the smart
device or make sure you are running
the latest version of the app.
- Launch the Dremel App on the smart
device and click on "Connect My
Tool" in the "My Dremel" section of
the app.
- Follow the app directions to pair the
tool with the smart device. To pair
the tool with the smart device using
Bluetooth technology, make sure the
tool is turned off and within 1 Meter /
3 Feet of the smart device.
- Once connected the connectivity
range with a clear line of sight is up
to 20 Meters / 65 Feet.
Operating Instructions
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
Whenever you hold
the tool, be careful
Fig. 7
8
7
Learn the Speeds
After the tool has been turned off:
- If you turn it back on within 5
minutes, the tool will turn on at its
last set speed setting.
- If turned on after 5 minutes, the tool
will turn on at its default speed
setting of 15,000 RPM.
Variable Speed Dial
Your tool is equipped with a variable
speed dial 8. The speed may be
adjusted during operation by rotating
the dial back or forth between any one
of the settings. One of the numbers on
the speed indicator 11 will light up
showing the current speed (Fig. 7).
Speed
Indicator
Number
5
10
•15
20
25
30
• Wire Brush Setting.
You can refer to the charts on page 20
to determine the proper speed, based
on the materi al being worked and the
type of accessory being used. These
16
11
10
9
Approximate Speed
Range, /min (RPM)
4,000-8,000
7,000–13,000
12,000–15,000
19,000–23,000
22,000–25,000
26,000–30,000
12